কোম্পানির খবর রোল ফর্মিং মেশিনের জীবনকাল

Life time of roll forming machine?

First of all, the surface of the tile pressing machine must be cleaned up. The upper die stamping process of the machine: the motor drives the input shaft through the pulley, the pinion and the large gear, drives the upper shaft, and the sliding seat with the upper mold is driven by a set of cam mechanisms Move up and down to achieve tile pressing.

The indexing of the working table is achieved by the gear set mounted on the end of the upper shaft, the transmission pin gear, and the groove wheel mounted on the hexagonal runner shaft to achieve indexing positioning. The return cam mounted on the same shaft and conjugated with the pressing cam realizes the positioning of the lower die in the working position through the positioning rod and the positioning disk. Lubricating pumps are installed in the left and right cabinets. When the machine is working, the oil pipe transfers lubricating oil to each frictional moving part. Those who understand the structure and performance of the machine and the operating procedures must not start the machine.

It is strictly forbidden to work beyond the normal small closed height, that is, the small distance between the bottom surface of the upper sliding box and the working surface is generally 290㎜. The height after the upper and lower molds is added, and the thickness of the upper and lower pads plus the thickness of the tile blank are not allowed to exceed 290㎜ The mold should be designed according to this requirement to avoid machine tool accidents.